Tubal Cain (1912–1998)
Forfatter af Hardening, Tempering and Heat Treatment (Workshop Practice)
Værker af Tubal Cain
Soldering and Brazing (Workship Practice, No 9) (Workship Practice, No 9) (Workshop Practice Series) (1800) 33 eksemplarer
Spring Design and Manufacture (Workshop Practice) (Workshop Practice) (Workshop Practice) (Workshop Practice) (1988) 25 eksemplarer
Soldering and Brazing Handbook for Home Machinists: Practical Information and Useful Exercises for the Small Shop (Fox… (2022) 3 eksemplarer
Satte nøgleord på
Almen Viden
- Juridisk navn
- Walshaw, Tom D.
- Fødselsdato
- 1912
- Dødsdag
- 1998-05-02
- Køn
- male
- Nationalitet
- United Kingdom
- Kort biografi
- Tom D. Walshaw (1912–1998) was an engineer, author and contributor to the British magazines Model Engineer and Engineering in Miniature. Many of his magazine contributions and books were authored under the pseudonym Tubal Cain. The pseudonym relates to the Tubal-cain, the biblical metal worker. As Tubal Cain he made over 424 contributions to Model Engineer, beginning in 1971. These were mainly divided between workshop equipment articles and model stationary engine constructional articles.[1] He graduated in mechanical engineering at Loughborough University in 1934.[2] and eventually, after a career in mechanical design, went back to that university in 1943, becoming, after some years, senior lecturer in mechanical engineering. He went on in 1948 to teach at University of Liverpool. In 1952 he was appointed Head of Department of Mechanical, Civil and Electrical Engineering at Darlington College of Technology. His final academic post was Head of Mechanical, Production and Civil Engineering at Lancashire Polytechnic. He gained the first of his many model engineering exhibition awards in 1949. At one point he was editor of the Transactions of the Newcomen Society. Walshaw died on 2 May 1998.[3]
Medlemmer
Anmeldelser
Måske også interessante?
Statistikker
- Værker
- 15
- Medlemmer
- 314
- Popularitet
- #75,177
- Vurdering
- 3.7
- Anmeldelser
- 3
- ISBN
- 23
- Sprog
- 1
.
Contents
Introduction
Section 1: Getting Hold Of The Job
Section 2: Jigs And Fixtures
Section 3: Round And About The Lathe
Section 4: Miscellaneous